
ACP 5080(R) GIANT
Dimensions of 580 x 2800 x 5000 mm offer extended possibilities for construction and design.
ACP 5080 GIANT and ACP 5080R GIANT open up completely new possibilities in construction and design. With dimensions of up to 580 x 2800 x 5000 mm, alimex is the world‘s leading manufacturer of aluminium cast plates worldwide that can offer its customers sawn or milled plates from 15 mm to 580 mm thickness in this width and length dimension. ACP 5080 GIANT and ACP 5080R GIANT have a fine-grained and low porosity cast aluminium structure. Due to specific heat treatment over an extended period of time, the material is homogenised and thermally relaxed. The dimensional stability is optimally maintained even under extreme machining conditions.
Technical data / specific properties
Chemical Composition
EN AW-5083 (AlMg4.5Mn0.7), according to DIN EN 573-3 / 3.3547
Material Properties
Machinability
very good (HSC/HPC excellent)
Weldability (TIG, MIG)
good (with S Al 5183)
Anodising Properties
good, not decorative
Polishing
very good
Corrosion Resistance
very good
Eroding Properties
good
Typical Mechanical Properties
Tensile Strength Rm
240-290 MPa (N/mm2)
0.2 % Yield Strength Rp 0.2
110-130 MPa (N/mm2)
Elongation A
min. 15 %
Brinell Hardness
74 (+/- 5) HB
Typical Physical Properties
Density
2.66 g/cm3
Thermal Conductivity
110 – 140 W/(mK)
Electrical Conductivity
16 – 19 MS/m (m/Ω mm2)
Modulus of Elasticity
~70,000 N/mm2
Coefficient of Thermal Expansion
24.2 * 10-6/K
ACP 5080 GIANT Special Sizes
Thickness
≥ 15 – 220 mm
Width
up to 2800 mm
Length
up to 5000 mm
(Maximum individual weight 5 t)
ACP 5080 GIANT Tolerances
Surface Finish Ra
≤ 0.25 µm
Tolerance in Thickness
+/- 0.1 mm
Flatness
on request
Tolerance (L/W) for cur pieces
≤ 150 mm thickness DIN ISO 2768-m
> 150 mm thickness 0/+ 5 mm
(Linear measured section 1 m)
(Other tolerances on request.)
ACP 5080R GIANT Special Sizes
Thickness
≥ 17 – 580 mm
Width
up to 2800 mm
Length
up to 5000 mm
(Maximum individual weight 20 t)
ACP 5080R GIANT Tolerances
Surface
sawn on all sides
Tolerance in Thickness
0/+ 2 mm
Tolerance (L/W) for cut pieces:
≤ 150 mm thickness DIN ISO 2768-m
> 150 mm thickness 0/+ 5 mm
(Linear measuring section 1 m)
(Other tolerances on request.)